EFFECT OF VARIOUS PROCESS PARAMETERS ON PUNCH AND DIE DESIGN IN DEEP DRAWING PROCESS

Dr. R . Venkat Reddy, V. Mounika, Dr. P. Ravikanth Raju

Abstract


The model is designed in CREO software. Analysis is done in ANSYS software for different materials. In this work static analysis is done for cup and punch to determine the deformation, stress and strain at different load conditions and for different materials by changing the geometry thickness. In this work the stress have been calculated theoretically and as well as using ansys and both results are compared. Modal analysis is done for cup to determine the deformation and frequency for different materials  by changing the geometry thicknesses. Random vibration analysis is done for cup to determine  the directional deformation, shear stress and shear strain for different materials by changing the geometry thickness.In this work the shear stress have been calculated theoretically and as well as using ansys and both results are compared.Transient analysis is done for cup to determine the  deformation, stress and strain for different materials by changing the geometry thickness with respect to time.


Keywords


Cup; Punch;Static Analysis; Random Analysis ; CREO Parametric;ANSYS;

References


Jay N.Mistri, K.D.Kothari,Gaurav, Kumar Sharma,Experimental and Simulation study of Deep drawing process-A review Journal of Advance Engineering and Research Development,Volume1,June,2014

Krupal T. Shah, Sandip Chaudhary, Darshan K.Bhatt, Analysis of the Effect of process parameters in Deep drawing Journal of Advance Engineering and Research Development,Volume1,May,2014

Chandra Pal Singh,GeetaAgnihotri of the Study of Deep drawing process parameter:A Review Journal of Mechanical Engineering Volume5,Feb 2015

P. Venkateshwar Reddy, Perumalla Janaki Ramulu, G. Sandhya Madhuri, Dasari Govardhan and PVS Ram Prasad ,Design and Analysis of Deep Drawing Process on angular Deep Drawing Dies for Different Anisotropic Materials Journal of Technical Analyst, CurlVeeTechnolabs, Hyderabad, India, Materials Science and Engineering 2016

Kopanathi Gowtham, K.V.N.S. Srikanth and K.L.N. Murty ,Simulation of the effect of Die Radius on Deep Drawing process Journal of CAD-CAM, Dept. of Mechanical Engineering, Godavari Institute of Engg. & Tech., Rajahmundry, India International Journal of Applied Research in Mechanical Engineering (IJARME) ISSN: 2231 –5950, Volume-2, Issue-1, 2012. april ,2008.


Full Text: PDF

Refbacks

  • There are currently no refbacks.




Copyright © 2012 - 2021, All rights reserved.| ijitr.com

Creative Commons License
International Journal of Innovative Technology and Research is licensed under a Creative Commons Attribution 3.0 Unported License.Based on a work at IJITR , Permissions beyond the scope of this license may be available at http://creativecommons.org/licenses/by/3.0/deed.en_GB.