DESIGNING A FLYWHEEL TO GENERATE HIGHER ENERGY IN SMALL CYCLE

Veluru Jaya Kishore, P Subramanyam

Abstract


In machines where the procedure is intermittent like punching machines, shearing machines, riveting machines, crushers etc., the flywheel stores energy in the source of energy throughout the greater portion, from the operating cycle and provides up throughout a small duration of the cycle. Thus the power in the source of energy to machines is provided practically in a constant rate through the operation. However, the flywheel has undoubtedly the finest inertia even just in a multi cylinder engine. Apart from its principle function, the fly wheel works as a person in the friction clutch, & it always carries even the ring gear from the electric starter. ANSYS Mechanical software provides a comprehensive product solution for structural straight line/nonlinear and dynamics analysis. The merchandise provides a complete group of elements behavior, material models and equation solvers for an array of engineering problems. Additionally, ANSYS Mechanical offers thermal analysis and coupled-physics abilities involving acoustic, piezoelectric, thermal-structural and thermal-electric analysis. SolidWorks utilizes a 3D design approach. While you design a component, in the initial sketch towards the final model, you develop a 3D entity. Out of this 3D entity, you may create 2D sketches, or mate different components to produce 3D assemblies. You may also create 2D sketches of 3D assemblies.


Keywords


Designing Flywheel; Multi Cylinder Inertia; Solid Works; ANSYS;

References


Selig, M.S., Lyon, C.A., Giguère, P., Ninham, C.P., and Guglielmo, J.J., Summary of Low-Speed Airfoil Data, Vol. 2, SoarTech Publications, H.A. Stokely (ed.), 1504 N. Horseshoe Circle, Virginia Beach, VA 23451, 1996, 252 pages.

Kathirvel, K., Job, T.V., Karunanithi, R., Swaminathan, K.R., 1991. “Energy expenditure pattern of power tiller operator”. Agricultural Mechanization in Asia, Africa and Latin America 22, 18–20.

Larrabee, E.E. and French, S.E. "Minimum Induced Loss Windmills and Propellers" Journal of Wind Engineering and Industrial Aerodynamics, 15 (1983) 317-327.

Kalsirisilp, R., 1993. “Performance Evaluation of a Thai- Made Rice Combine Harvester”. Asian Institute of Technology, M.Eng.Thesis No. AE 93-46.

Finite Element ModellingAnd Analysis of Skin Panel Based On the Fiber Orientation and Stacking Sequence by “Dr.R.Rajappan, Dr.S.Sundararaj and V.Pugazhenthi”


Full Text: PDF

Refbacks

  • There are currently no refbacks.




Copyright © 2012 - 2021, All rights reserved.| ijitr.com

Creative Commons License
International Journal of Innovative Technology and Research is licensed under a Creative Commons Attribution 3.0 Unported License.Based on a work at IJITR , Permissions beyond the scope of this license may be available at http://creativecommons.org/licenses/by/3.0/deed.en_GB.